Order separately the single wire seal or the hoods/housings for an IP65 performance.
Details
A Han® 1A configuration that only consists of inserts (with or without strain relief, 09 10 000 5300) is an unenclosed connector according to IEC 61984. In this case protection against electric shock must be provided by the installation methods of the user.
Contact inserts must not be coupled or decoupled under electrical load.
Connector must not be powered-up in the unmated condition.
Contact inserts with screw termination technology (2+PE and 3+PE) only differ in the number of contacts. If both variants are used in one application, the user must prevent incorrect mating! Safety instructions according to VDE 0100-410, Chapter 414.4.3 and EN 60204-1, Chapter 13.4.5 d) must be observed.
Conductor cross-section (mm²)
[0,75] ... [1,5 mm²]
Rated current
10 A
Rated voltage conductor-earth
230 V
Rated voltage conductor-conductor
400 V
Rated impulse voltage
4 kV
Pollution degree
3
Rated voltage acc. to UL
250 V
Rated current acc. to UL
[10 A] AWG 16
Insulation resistance
>108 Ω
Limiting temperature
[-40] ... [+90 °C]
Tightening torque
[0,25 Nm]
Mating cycles
100
Degree of protection acc. to IEC 60529
IP20
ECHA SCIP number
5dbb3851-b94e-4e88-97a1-571845975242
Fire protection on railway vehicles
EN 45545-2 (2020-08) + A1 (2023-10)
China RoHS
50
RoHS
compliant with exemption
REACH SVHC substances
Yes
REACH Annex XVII substances
Not contained
REACH ANNEX XIV substances
Not contained
Requirement set with Hazard Levels
R22 (HL 1-3)
R23 (HL 1-3)
ELV status
compliant with exemption
California Proposition 65 substances
Yes
RoHS exemptions
6(c): Copper alloy containing up to 4 % lead by weight
